When you install ChatEditor, messages similar to the following will be displayed:
- You must attach a PCS-configured NovaChat or Via Device to enable and display PCS Symbols.
- Click OK to continue.
- Speech is currently disabled. Please connect a NovaChat/ChatFusion or Via device to this computer to enable speech.
- Choose OK to close the message.
To enable speech or symbols in ChatEditor, simply connect a USB cable between your computer and your device.
Note: If a message prompts you to allow access, you must tap Allow to proceed.
Test the Editor to verify that speech is working or symbols are displaying. Then disconnect the cable.
Speech and symbols will now be enabled whenever you use the Editor; you will not need to re-connect the cable.